      |
 |
SM82 series
The Computronic SM82 battery charger uses switch mode power supply technology to give a compact, lightweight design with high power efficiency and low heat dissipation. Fast, accurate and smooth charging ensures optimum battery life and reliability.
The SM82 is intended for continuous float charging and standby battery applications, including standby engines, pumps and generators. The DC output gives rapid charging at maximum current until the battery reaches a ‘knee point’ voltage (13 VDC for 12V lead acid). The output then ramps down to its float voltage, maintaining optimum battery charge and supporting static loads up to the maximum rated current.
Features:
- Fully automatic output: 3A max @ 24VDC, or 5 Amps max @ 12VDC
- Suitable for wet Lead Acid, NiCd, VRLA or Plante cells
- Float or boost operation, selected by remote contacts
- 230 or 110VAC power supply, selected by circuit board link
- Charge fail relay output
- Open circuit board or protective cover versions
Literature:
For more information about this product, you can view the related literature here:
Inside this section:
Engine mounted devices:-
- RP2300 series – Push/pull solenoids for diesel engines
- RP75 – Rack pullers for diesel engines
- AT03069 – Murphymatic® engine throttle controller
- CO3 – Electric motor-driven clutch operator for engine automation systems.
Engine control modules:-
- Keystart – Manual start/stop control with automatic fault shutdown
- CANstart™ – Control, indication and protection for J1939 engines.
- CASCADE – Automatic engine control and protection, J1939 compatible
- ASM150 – Automatic engine control and protection
- ASM170 – Automatic engine control and protection
- Autostart - engine / genset control range
Battery chargers:-